| HomeRobotics | HomeAutomation | Racing | 1/24 Models | Mustang | Family | PaPa |

69stang.gif (5918 bytes)
The Rebuild March 20th, 2010
Last Update: 03/21/10
Back to the Stang Page | Back to Rebuild Page | Prev


3/20/2010 Ignition / ZEX / AC?

Another year gone by - another non-69 Stang productive year gone. Spent most of the last year on the 1985 SVO. Fun car, running good enough for now, hopefully back on this for a while.
   
Driven partly by my son's desire to work on the 69 car more, we mounted up the ignition, the nitrous controller, and I mocked up the dealer add on AC box.
MSD 6AL and Coil
Mounting MSD
Austin working on mounting the 6AL and Coil
MSD Mounted
All Mounted Up - just need to run wires and wire it up.
ZEX Mounted
ZEX Nitrous controller mounted. This is directly behind the dash panel that is easy to get off. In fact I might use some quick fasteners to make it even easier to remove.
We also replaced the computer with a A9L I picked up.
AC Mounted
This shows the old dealer add on underdash AC unit mounted. Had to make a couple hangers to get it setup. There is a control face on the drivers side as this was made specifically for 69-70 Mustangs.
I can't believe how DUSTY things get just sitting there a year.. :-(
9" Housing
Also been working on cleaning up the narrower 9" housing before welding the mounting pads on it. This came out of a Nova so it had coil brackets on it and loads of nasty welds, etc. Just trying to make it a little better, not show perfect.
   

Back to the Stang Page | Back to Rebuild Page | Prev